What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Power | power | W | read only |
| Power reactive | power_reactive | VAr | read only |
| Interface mode | interface_mode | norwegian_han, norwegian_han_extra_load, aidon_meter, kaifa_and_kamstrup | settable |
| Voltage | voltage | V | read only |
| Current | current | A | read only |
| Energy | energy | kWh | read only |
| Produced energy | produced_energy | kWh | read only |
| Voltage phase B | voltage_phase_b | V | read only |
| Voltage phase C | voltage_phase_c | V | read only |
| Current phase B | current_phase_b | A | read only |
| Current phase C | current_phase_c | A | read only |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"power": 12.4,
"power_reactive": 0,
"interface_mode": "norwegian_han",
"voltage": 230,
"current": 0.06,
"energy": 3.21,
"produced_energy": 0,
"voltage_phase_b": 0,
"voltage_phase_c": 0,
"current_phase_b": 0,
"current_phase_c": 0,
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"interface_mode":"norwegian_han_extra_load"}'
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.