What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Temperature | temperature | °C | read only |
| Tds | tds | ppm | read only |
| Tds coefficient | tds_coefficient | 500, 550, 640, 700, 1000 | settable |
| Reading interval | reading_interval | Seconds · 10…360 | settable |
| Tds offset | tds_offset | ppm · -100…100 | settable |
| Tx radio power | tx_radio_power | 4dbm, 19dbm | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"temperature": 21.6,
"tds": 0,
"tds_coefficient": "500",
"reading_interval": 185,
"tds_offset": 0,
"tx_radio_power": "4dbm",
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"tds_coefficient":"550"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"tx_radio_power":"19dbm"}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Room too warm"
mode: single
triggers:
- trigger: numeric_state
entity_id: sensor.my_device_temperature
above: 26
for: "00:10:00"
actions:
- action: notify.notify
data:
message: "Temperature above 26 °C"
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.