What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Presence | presence | — | read only |
| Switch 1 | switch_1 | — | settable |
| Switch 2 | switch_2 | — | settable |
| Switch 3 | switch_3 | — | settable |
| Sensitivity | sensitivity | 0…19 | settable |
| Backlight | backlight | — | settable |
| Trigger hold | trigger_hold | s · 5…28800 | settable |
| Remember state after power loss | power_outage_memory | on, off, restore | settable |
| Auto on | auto_on | off, all, ch1, ch2, ch3, ch1_and_ch2, ch2_and_ch3, ch1_and_ch3 | settable |
| Auto off | auto_off | off, all, ch1, ch2, ch3, ch1_and_ch2, ch2_and_ch3, ch1_and_ch3 | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"presence": false,
"switch_1": false,
"switch_2": false,
"switch_3": false,
"sensitivity": 10,
"backlight": false,
"trigger_hold": 14403,
"power_outage_memory": "on",
"auto_on": "off",
"auto_off": "off",
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"switch_1":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"switch_2":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"switch_3":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"backlight":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"power_outage_memory":"off"}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Light on motion"
mode: single
triggers:
- trigger: state
entity_id: binary_sensor.my_device_presence
to: "on"
conditions:
- condition: sun
after: sunset
actions:
- action: light.turn_on
target:
entity_id: light.hallway
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.