What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Climate (3) | local_temperature, local_temperature_calibration, occupied_heating_setpoint, system_mode, running_mode | room temperature, local_temperature_calibration, heating setpoint, mode, running_mode | settable |
| Climate (4) | local_temperature, local_temperature_calibration, occupied_heating_setpoint, system_mode, running_mode | room temperature, local_temperature_calibration, heating setpoint, mode, running_mode | settable |
| Identify | identify | identify | settable |
| Occupied setback (3) | occupied_setback_3 | °C · 1…2.5 | settable |
| Occupied setback (4) | occupied_setback_4 | °C · 1…2.5 | settable |
| Remote sensing (3) | remote_sensing_3 | internally, remotely | settable |
| Remote sensing (4) | remote_sensing_4 | internally, remotely | settable |
| Sensor (3) | sensor_type_3 | 3.3K, 5.0K, 6.8K, 10.0K, 12.0K, 14.8K, 15.0K, 20.0K … | settable |
| Sensor (4) | sensor_type_4 | 3.3K, 5.0K, 6.8K, 10.0K, 12.0K, 14.8K, 15.0K, 20.0K … | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"local_temperature": 20.5,
"occupied_heating_setpoint": 21,
"system_mode": "heat",
"occupied_setback_3": 2,
"occupied_setback_4": 2,
"remote_sensing_3": "internally",
"remote_sensing_4": "internally",
"sensor_type_3": "3.3K",
"sensor_type_4": "3.3K",
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"occupied_heating_setpoint":21.5}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"system_mode":"heat"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"occupied_heating_setpoint":21.5}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"system_mode":"heat"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"remote_sensing_3":"remotely"}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Cooler at night"
mode: single
triggers:
- trigger: time
at: "23:00:00"
actions:
- action: climate.set_temperature
target:
entity_id: climate.my_device
data:
temperature: 18
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.