What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Action (button press) | action | input_1_on, input_1_off, input_1_toggle, input_1_single, input_1_double, input_1_triple, input_1_hold | read only |
| Switch type (sw1) | switch_type_sw1 | toggle, momentary | settable |
| On / off | state | — | settable |
| Wi-Fi status | wifi_status | — | read only |
| IP address | ip_address | — | read only |
| DHCP enabled | dhcp_enabled | — | read only |
| Wi-Fi Configuration | wifi_config | — | read only |
| Identify | identify | identify | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"switch_type_sw1": "toggle",
"state": "ON",
"dhcp_enabled": false,
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state":"TOGGLE"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"switch_type_sw1":"momentary"}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Off at night"
mode: single
triggers:
- trigger: time
at: "23:30:00"
actions:
- action: switch.turn_off
target:
entity_id: switch.my_device
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.