What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Device temperature | device_temperature | °C | read only |
| Power | power | W | read only |
| Voltage | voltage | V | read only |
| Current | current | A | read only |
| Energy | energy | kWh | read only |
| Power phase b | power_phase_b | W | read only |
| Power phase c | power_phase_c | W | read only |
| Voltage phase B | voltage_phase_b | V | read only |
| Voltage phase C | voltage_phase_c | V | read only |
| Current phase B | current_phase_b | A | read only |
| Current phase C | current_phase_c | A | read only |
| Energy tier 1 | energy_tier_1 | kWh | read only |
| Energy tier 2 | energy_tier_2 | kWh | read only |
| Energy tier 3 | energy_tier_3 | kWh | read only |
| Energy tier 4 | energy_tier_4 | kWh | read only |
| Model name | model_name | — | read only |
| Serial number | serial_number | — | read only |
| Date release | date_release | — | read only |
| Battery life | battery_life | % | read only |
| Tamper | tamper | — | read only |
| Low battery | battery_low | — | read only |
| Device address preset | device_address_preset | 1…99999999 | settable |
| Device password preset | device_password_preset | — | settable |
| Device measurement preset | device_measurement_preset | 1…255 | settable |
| Device model preset | device_model_preset | no_device, NARTIS-I300 | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"device_temperature": 31,
"power": 12.4,
"voltage": 2950,
"current": 0.06,
"energy": 3.21,
"power_phase_b": 0,
"power_phase_c": 0,
"voltage_phase_b": 0,
"voltage_phase_c": 0,
"current_phase_b": 0,
"current_phase_c": 0,
"energy_tier_1": 0,
"energy_tier_2": 0,
"energy_tier_3": 0,
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"device_model_preset":"NARTIS-I300"}'
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.