What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Identify | identify | identify | settable |
| Power | power | W | read only |
| Current | current | A | read only |
| Energy | energy | kWh | read only |
| Power failure mode | power_failure_mode | last_state, off, on, blink | settable |
| Actual order | actual_order | stop, frost_off, eco, confort_2, confort_1, confort, shortcut_error, temperature_error | read only |
| Order timer | order_timer | 0…4294967295 | settable |
| Pre order timer | pre_order_timer | 0…4294967295 | settable |
| Timer unit | timer_unit | second, minutes | settable |
| Led mode | led_mode | led_on, led_off | settable |
| Pilot wire relay mode | pilot_wire_relay_mode | relay_on, relay_off | settable |
| Order scrolling mode | order_scrolling_mode | forward, backward | settable |
| Order number supported | order_number_supported | four_orders, six_orders | settable |
| Fallback order | fallback_order | stop, frost_off, eco, confort_2, confort_1, confort | settable |
| Pilotwire set order | pilotwire_set_order | stop, frost_off, eco, confort_2, confort_1, confort | settable |
| Pilotwire toggle order | pilotwire_toggle_order | pilotwire_toggle_order | settable |
| Reset to factory settings | reset_to_factory_settings | factory_reset, configuration_reset, network_reset | settable |
| Relaunch ble advert | relaunch_ble_advert | relaunch_ble_advert | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"power": 12.4,
"current": 0.06,
"energy": 3.21,
"power_failure_mode": "last_state",
"actual_order": "stop",
"order_timer": 2147483648,
"pre_order_timer": 2147483648,
"timer_unit": "second",
"led_mode": "led_on",
"pilot_wire_relay_mode": "relay_on",
"order_scrolling_mode": "forward",
"order_number_supported": "four_orders",
"fallback_order": "stop",
"pilotwire_set_order": "stop",
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"power_failure_mode":"off"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"timer_unit":"minutes"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"led_mode":"led_off"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"pilot_wire_relay_mode":"relay_off"}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"order_scrolling_mode":"backward"}'
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.