What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Battery | battery | % · 0…100 | read only |
| On / off | state | — | settable |
| Mode | mode | duration, capacity | settable |
| Cycle irrigation num times | cycle_irrigation_num_times | 0…100 | settable |
| Irrigation start time | irrigation_start_time | — | read only |
| Irrigation end time | irrigation_end_time | — | read only |
| Last irrigation duration | last_irrigation_duration | — | read only |
| Water consumed | water_consumed | L | read only |
| Irrigation target | irrigation_target | seconds or litres · 0…43200 | settable |
| Cycle irrigation interval | cycle_irrigation_interval | sec · 0…43200 | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"battery": 87,
"state": false,
"mode": "duration",
"cycle_irrigation_num_times": 50,
"water_consumed": 0,
"irrigation_target": 21600,
"cycle_irrigation_interval": 21600,
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"mode":"capacity"}'
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.