What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Light (l1) | state, brightness | on / off, brightness | settable |
| Light (l2) | state, brightness | on / off, brightness | settable |
| Light (s1) | state, brightness | on / off, brightness | settable |
| Light effect (l1) | effect_l1 | blink, breathe, okay, channel_change, finish_effect, stop_effect | settable |
| Light effect (l2) | effect_l2 | blink, breathe, okay, channel_change, finish_effect, stop_effect | settable |
| Effect (s1) | effect_s1 | blink, breathe, okay, channel_change, finish_effect, stop_effect | settable |
| Action (button press) | action | toggle_s1, brightness_move_up_s1, brightness_move_down_s1, brightness_stop_s1 | read only |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"state_l1": "ON",
"brightness_l1": 180,
"state_l2": "ON",
"brightness_l2": 180,
"state_s1": "ON",
"brightness_s1": 180,
"effect_s1": "blink",
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state_l1":"ON","brightness_l1":180}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state_l1":"OFF","transition":2}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state_l2":"ON","brightness_l2":180}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state_l2":"OFF","transition":2}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"state_s1":"ON","brightness_s1":180}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Light at sunset"
mode: single
triggers:
- trigger: sun
event: sunset
offset: "-00:15:00"
actions:
- action: light.turn_on
target:
entity_id: light.my_device
data:
brightness_pct: 70
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.