What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Status | status | unoccupied, occupied, sitting, on_the_bed, low_posture, falling | read only |
| Breathing rate | breathing_rate | breaths/min | read only |
| Location x | location_x | cm | read only |
| Location y | location_y | cm | read only |
| Fall detection settings | fall_detection_settings | — | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"status": "unoccupied",
"breathing_rate": 0,
"location_x": 0,
"location_y": 0,
"linkquality": 120
}
The device only reports data and takes no commands.
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.