What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Energy | energy | kWh | read only |
| Produced energy | produced_energy | kWh | read only |
| Combined energy | combined_energy | kWh | read only |
| Power | power | W | read only |
| Power reactive | power_reactive | VAR | read only |
| Power apparent | power_apparent | VA | read only |
| AC frequency | ac_frequency | Hz | read only |
| Power factor | power_factor | — | read only |
| Voltage | voltage_l1 | V | read only |
| Current | current_l1 | A | read only |
| Power | power_l1 | W | read only |
| Power reactive l1 | power_reactive_l1 | var | read only |
| Power apparent l1 | power_apparent_l1 | VA | read only |
| Power factor | power_factor_l1 | — | read only |
| Voltage | voltage_l2 | V | read only |
| Current | current_l2 | A | read only |
| Power | power_l2 | W | read only |
| Power reactive l2 | power_reactive_l2 | var | read only |
| Power apparent l2 | power_apparent_l2 | VA | read only |
| Power factor | power_factor_l2 | — | read only |
| Voltage | voltage_l3 | V | read only |
| Current | current_l3 | A | read only |
| Power | power_l3 | W | read only |
| Power reactive l3 | power_reactive_l3 | var | read only |
| Power apparent l3 | power_apparent_l3 | VA | read only |
| Power factor | power_factor_l3 | — | read only |
| Alarm status | alarm_status | — | read only |
| Over current threshold | over_current_threshold | A · 1…63 | settable |
| Over voltage threshold | over_voltage_threshold | V · 230…300 | settable |
| Under voltage threshold | under_voltage_threshold | V · 90…190 | settable |
| Clear energy | clear_energy | press | settable |
| Refresh measurements | refresh_measurements | press | settable |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"energy": 3.21,
"produced_energy": 0,
"combined_energy": 0,
"power": 12.4,
"power_reactive": 0,
"power_apparent": 0,
"ac_frequency": 0,
"power_factor": 0,
"voltage_l1": 230,
"current_l1": 0.06,
"power_l1": 12.4,
"power_reactive_l1": 0,
"power_apparent_l1": 0,
"power_factor_l1": 0,
"linkquality": 120
}
The device only reports data and takes no commands.
Watch the topics live from the browser: MQTT client.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.