Antsig Smart Wi-Fi IR Universal Remote (HUBIR01HA): ESPHome

Starter ESPHome config

Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.

substitutions:
  name: antsig-smart-wi-fi-ir-un

esphome:
  name: ${name}
  friendly_name: "Antsig Smart Wi-Fi IR Universal Remote (HUBIR01HA)"

bk72xx:
  board: generic-bk7231n-qfn32-tuya  # BK7231T or BK7231N: check the chip marking

logger:
api:
  encryption:
    key: !secret api_key
ota:
  - platform: esphome
    password: !secret ota_password
wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap: {}
captive_portal:

binary_sensor:
  - platform: gpio
    pin:
      number: P6
      mode: INPUT_PULLUP
      inverted: true
    name: "Button"  # Reset button (active low)

status_led:
  pin:
    number: P8
    inverted: true  # Status LED

# Other pins from the pinout:
#   P7: IR Receiver
#   P26: IR Blaster Output

How to flash

• Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
• Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
• Details and board photos: the device page in the ESPHome database.

A config from scratch: ESPHome generator. Which pins are safe: pinout.

Similar devices

• Airtap T Series 3btn PCB by SiloCityLabs
• Airtap T Series 4btn PCB by SiloCityLabs
• Athom AR01 IR Controller
• AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity)
• AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity) - New Version
• AVATTO S06Pro WiFi IR Universal Remote Controller