Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: athom-br30-bulb
esphome:
name: ${name}
friendly_name: "Athom BR30 Bulb"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO13: CT Output
# GPIO5: CT Brightness Output
# GPIO4: Red Output
# GPIO12: Green Output
# GPIO14: Blue Output
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- Arlec Grid Connect Smart E27 LED 830lm RGB CCT Colour Mode 10W Globe (GLD322HA)
- Arlec Grid Connect Smart GU10 LED 420lm RGB CCT Colour Mode 5.5W Globe (GLD381HA)
- Arlec Grid Connect Smart LED Globe CWWW (GLD112HA)
- Arlec Smart 2m/5m LED Strip Light
- Athom E27 15W Bulb
- Athom E27 7W Bulb
- Athom GU10 Bulb
- Avita Domus AS-SB-10W-5C RGBCCT 10 Watt Light Bulb