Blitzwolf BW-SHP7 Double socket with powermonitoring: ESPHome

Starter ESPHome config

Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.

substitutions:
  name: blitzwolf-bw-shp7-double

esphome:
  name: ${name}
  friendly_name: "Blitzwolf BW-SHP7 Double socket with powermonitoring"

esp8266:
  board: esp01_1m  # most plugs and relays have 1 MB flash; check yours

logger:
api:
  encryption:
    key: !secret api_key
ota:
  - platform: esphome
    password: !secret ota_password
wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap: {}
captive_portal:

switch:
  - platform: gpio
    pin: GPIO14
    id: relay1
    name: "Relay 1"  # Relay1
    restore_mode: RESTORE_DEFAULT_OFF
  - platform: gpio
    pin: GPIO16
    id: relay2
    name: "Relay 2"  # Relay2
    restore_mode: RESTORE_DEFAULT_OFF

binary_sensor:
  - platform: gpio
    pin:
      number: GPIO0
      mode: INPUT_PULLUP
      inverted: true
    name: "Button 1"  # Button1 (pullup, inverted)
    on_press:
      - switch.toggle: relay1
  - platform: gpio
    pin:
      number: GPIO12
      mode: INPUT_PULLUP
      inverted: true
    name: "Button 2"  # Button2 (pullup, inverted)
    on_press:
      - switch.toggle: relay2

status_led:
  pin:
    number: GPIO13
    inverted: true  # Red LED1(inverted)

sensor:
  - platform: hlw8012
    sel_pin:
      number: GPIO3
      inverted: true
    cf_pin: GPIO4
    cf1_pin: GPIO5
    voltage:
      name: "Voltage"
    current:
      name: "Current"
    power:
      name: "Power"
    energy:
      name: "Energy"
    update_interval: 10s
    # calibrate voltage_divider and current_resistor against a known load

# Other pins from the pinout:
#   GPIO2: Red LED2(inverted)
#   GPIO1: Blue LED (inverted)

How to flash

• Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
• Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
• Details and board photos: the device page in the ESPHome database.

A config from scratch: ESPHome generator. Which pins are safe: pinout.

Similar devices

• Bauhn (ALDI) ASPU-1019 Plug
• BlitzWolf BW-SHP2 Power Monitoring Plug
• BlitzWolf BW-SHP3 Power Monitoring Plug
• Blitzwolf BW-SHP6 Socket with powermonitoring
• BlitzWolf BW-SHP8 Power Monitoring Wall Outlet
• Blitzwolf BW-SHP9 Triple powerstrip with dual USB power
• Brilliant Lighting BL20925 Power Monitoring Plug
• Brilliant Smart Plug