Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: brilliant-smart-wifi-pow
esphome:
name: ${name}
friendly_name: "Brilliant Smart WiFi Powerboard 20691/05"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
switch:
- platform: gpio
pin: GPIO4
id: relay1
name: "Relay 1" # Relay1 (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO12
id: relay2
name: "Relay 2" # Relay3 (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO13
id: relay3
name: "Relay 3" # Relay2 (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO14
id: relay4
name: "Relay 4" # Relay4 (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO16
id: relay5
name: "Relay 5" # Relay5
restore_mode: RESTORE_DEFAULT_OFF
binary_sensor:
- platform: gpio
pin:
number: GPIO14
mode: INPUT_PULLUP
inverted: true
name: "Button 1" # Push Button (Inverted: true)
on_press:
- switch.toggle: relay1
- platform: gpio
pin:
number: GPIO5
mode: INPUT_PULLUP
inverted: true
name: "Button 2" # Button1
on_press:
- switch.toggle: relay2
status_led:
pin:
number: GPIO0
inverted: true # Led1 (Inverted: true)
# Other pins from the pinout:
# GPIO13: Red LED (Inverted: true)
# GPIO3: Led2 (Inverted: true)
# GPIO1: None
# GPIO2: None
# GPIO9: None
# GPIO10: None
# GPIO15: None
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.