Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: gosund-wo1-wall-outlet
esphome:
name: ${name}
friendly_name: "Gosund WO1 Wall Outlet"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
switch:
- platform: gpio
pin: GPIO0
id: relay1
name: "Relay 1" # Top outlet LED (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO13
id: relay2
name: "Relay 2" # Bottom outlet LED (Inverted: true)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO14
id: relay3
name: "Relay 3" # Bottom outlet relay
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO15
id: relay4
name: "Relay 4" # Top outlet relay
restore_mode: RESTORE_DEFAULT_OFF
status_led:
pin:
number: GPIO2
inverted: true # Status LED (Inverted: true)
sensor:
- platform: hlw8012
model: BL0937
sel_pin:
number: GPIO12
inverted: true
cf_pin: GPIO5
cf1_pin: GPIO4
voltage:
name: "Voltage"
current:
name: "Current"
power:
name: "Power"
energy:
name: "Energy"
update_interval: 10s
# calibrate voltage_divider and current_resistor against a known load
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.