Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: kincony-kc868-uair
esphome:
name: ${name}
friendly_name: "KinCony KC868-Uair"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
status_led:
pin:
number: GPIO32
inverted: false # 4\WS2812B LED Bottom
# Other pins from the pinout:
# GPIO33: 1\WS2812B LED vertical bar
# GPIO2: 433MHz Transmitter
# GPIO13: 433MHz Receiver
# GPIO19: IR Receiver
# GPIO22: IR Transmitter
# GPIO26: Buzzer
# GPIO4: IIC_SDA
# GPIO16: IIC_SCL
# GPIO27: DS18B20 Temperature sensor
# GPIO15: Free GPIO
# GPIO5: Free GPIO
# GPIO21: Free GPIO
# GPIO25: Free GPIO
# GPIO36: Free GPIO
# GPIO34: Free GPIO
# GPIO17: Free GPIO
# GPIO18: Free GPIO
# GPIO23: Free GPIO
# GPIO14: Free GPIO
# GPIO39: Free GPIO
# GPIO35: Free GPIO
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.