Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: martin-jerry-mj-st02
esphome:
name: ${name}
friendly_name: "Martin Jerry MJ-ST02"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO1: Tuya Tx
# GPIO3: Tuya Rx
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- LSPS5 Tuya Switch 1-2-3 Gang No Neutral
- Make Good MG-MD04W 4-Gang Wifi Switch with Power Monitoring
- Martin Jerry MJ-S01 Switch
- Martin Jerry MJ-ST01 3-Way Switch
- Martin Jerry US-FC-01 Smart Ceiling Fan Controller
- Martin Jerry US-SS01
- Martin Jerry US-SS02 Humidity Sensor Switch
- Martin Jerry Wall Switch MJ-S01