Mirabella Genio Wi-Fi 1.4m Pixel LED Corner Light: ESPHome

Starter ESPHome config

Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.

substitutions:
  name: mirabella-genio-wi-fi-1-

esphome:
  name: ${name}
  friendly_name: "Mirabella Genio Wi-Fi 1.4m Pixel LED Corner Light"

rtl87xx:
  board: generic-rtl8710bn-2mb-788k  # check your module

logger:
api:
  encryption:
    key: !secret api_key
ota:
  - platform: esphome
    password: !secret ota_password
wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap: {}
captive_portal:

binary_sensor:
  - platform: gpio
    pin:
      number: PA12
      mode: INPUT_PULLUP
      inverted: true
    name: "Button 1"  # PWR Push Button
  - platform: gpio
    pin:
      number: PA05
      mode: INPUT_PULLUP
      inverted: true
    name: "Button 2"  # LED Push Button
  - platform: gpio
    pin:
      number: PA00
      mode: INPUT_PULLUP
      inverted: true
    name: "Button 3"  # Sound Push Button

# Other pins from the pinout:
#   PA23?: Light - Data

How to flash

• Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
• Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
• Details and board photos: the device page in the ESPHome database.

A config from scratch: ESPHome generator. Which pins are safe: pinout.

Similar devices

• MagicHome RGBW ZJ-WFMN-A V1.1 LED Controller
• MagicHome-ZJ-WFMN-C-Single Color V1.1 LED Controller
• MiBoxer WL5 WiFi 5 in 1 LED Strip Controller
• Mirabella Genio White Bulb
• Mirabella Genio Wi-Fi 500 LED Mulitcoloured Fairy Lights
• Mirabella Genio Wi-Fi Dimmable Warm White ES 9W LED GLS Bulb
• Mirabella Genio Wi-Fi SES LED Candle
• Mirabella Genio Wi-Fi Strip Light