Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: petkit-fresh-element-sol
esphome:
name: ${name}
friendly_name: "Petkit Fresh Element Solo Pet Feeder"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO34
mode: INPUT_PULLUP
inverted: true
name: "Button" # Feed button
status_led:
pin:
number: GPIO5
inverted: true # Status LED
# Other pins from the pinout:
# GPIO16: RTTTL Buzzer
# GPIO27: Feeder motor sensor
# GPIO14: Food optical sensor
# GPIO19: Feeder motor control\
# GPIO33: Feeder sensors control\
# GPIO18: Feed forward control\
# GPIO17: Reverse feed control\
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.