Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: shelly-h-t-gen3
esphome:
name: ${name}
friendly_name: "Shelly H&T Gen3"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO0
mode: INPUT_PULLUP
inverted: true
name: "Button" # Button
# Other pins from the pinout:
# GPIO1: I2C SDA
# GPIO2: Power Rail ADC
# GPIO3: I2C SCL
# GPIO4: Battery ADC
# GPIO5: Battery Presence
# GPIO6: UC8119 BUSY_N
# GPIO7: UC8119 RESET_N
# GPIO8: USB Detect
# GPIO10: UC8119 Enable
# GPIO18: Batt Power En
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.