Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: sonoff-pow-elite-20a-pow
esphome:
name: ${name}
friendly_name: "Sonoff POW Elite 20a (POWR320D)"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
switch:
- platform: gpio
pin: GPIO2
id: relay1
name: "Relay 1" # Relay1 (320D - bi-stable - On)
restore_mode: RESTORE_DEFAULT_OFF
- platform: gpio
pin: GPIO4
id: relay2
name: "Relay 2" # Relay1 (320D - bi-stable - Off)
restore_mode: RESTORE_DEFAULT_OFF
binary_sensor:
- platform: gpio
pin:
number: GPIO0
mode: INPUT_PULLUP
inverted: true
name: "Button" # Push Button (HIGH = off, LOW = on)
on_press:
- switch.toggle: relay1
status_led:
pin:
number: GPIO5
inverted: false # Wifi_LED
# Other pins from the pinout:
# GPIO18: Status LED (HIGH = off, LOW = on)
# GPIO14: TM1621 DA
# GPIO16: CSE7766 Rx
# GPIO25: TM1621 CS
# GPIO26: TM1621 RD
# GPIO27: TM1621 WR
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.