What it exposes
| Feature | Property | Values | Control |
|---|---|---|---|
| Battery | battery | % · 0…100 | read only |
| Identify | identify | identify | settable |
| Temperature | temperature | °C | read only |
| Alarm | alarm | — | read only |
| Low battery | battery_low | — | read only |
| Test | test | — | read only |
| Tamper | tamper | — | read only |
| Fault state | fault_state | — | read only |
| Muted | muted | — | read only |
| Trigger selftest | trigger_selftest | test | settable |
| Temporary mute | temporary_mute | — | settable |
| Heartbeat indicator | heartbeat_indicator | — | settable |
| Interconnectable | interconnectable | — | read only |
| Siren for automation only | siren_for_automation_only | stop, smoke_siren, co_siren, heat_siren | settable |
| Temperature offset | temperature_offset | -15…15 | settable |
| Link available | link_available | inactive, smoke_active, co_active, gas_active, heat_active | read only |
| Reported packages | reported_packages | 0…60000 | read only |
| Rejoin count | rejoin_count | 0…60000 | read only |
| Reboot count | reboot_count | 0…60000 | read only |
MQTT: state and commands
Zigbee2MQTT publishes the device state to zigbee2mqtt/my_device (my_device is the name you give the device). An example message:
{
"battery": 87,
"temperature": 21.6,
"alarm": false,
"battery_low": false,
"test": false,
"tamper": false,
"trigger_selftest": "test",
"temporary_mute": false,
"heartbeat_indicator": false,
"interconnectable": false,
"siren_for_automation_only": "stop",
"temperature_offset": 0,
"link_available": "inactive",
"reported_packages": 30000,
"linkquality": 120
}
Send commands to zigbee2mqtt/my_device/set:
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"temporary_mute":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"heartbeat_indicator":true}'
mosquitto_pub -t zigbee2mqtt/my_device/set -m '{"siren_for_automation_only":"smoke_siren"}'
Watch the topics live from the browser: MQTT client.
Home Assistant automation example
Zigbee2MQTT creates Home Assistant entities from the device name. If it is called my_device, an automation in automations.yaml can look like this:
- alias: "Room too warm"
mode: single
triggers:
- trigger: numeric_state
entity_id: sensor.my_device_temperature
above: 26
for: "00:10:00"
actions:
- action: notify.notify
data:
message: "Temperature above 26 °C"
Check the YAML: YAML checker.
How to pair it
- In Zigbee2MQTT click Permit join.
- Put the device in pairing mode: usually a long press of the reset button (5–10 s) until the LED blinks; bulbs: switch the power off and on 5–6 times.
- Keep the device close to the coordinator or a router while pairing.
- Give it a clear name: MQTT topics and Home Assistant entities are built from it.
Exact procedure and model notes: the device page in the Zigbee2MQTT docs. No coordinator yet: coordinator picker.