Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: avatto-tuya-wifi-smart-s
esphome:
name: ${name}
friendly_name: "AVATTO Tuya WiFi Smart Switch Modul"
bk72xx:
board: generic-bk7231n-qfn32-tuya # BK7231T or BK7231N: check the chip marking
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO8
mode: INPUT_PULLUP
inverted: true
name: "Button" # Button
status_led:
pin:
number: GPIO6
inverted: true # Blue Status LED
# Other pins from the pinout:
# GPIO14: S1 Input
# GPIO20: Relais
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- Athom AR01 IR Controller
- AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity)
- AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity) - New Version
- AVATTO S06Pro WiFi IR Universal Remote Controller
- BlitzHome BH-AP1
- BlitzWolf BH-AP2501
- BudapestMetroDisplay
- CircuitSetup Expandable-6 Channel ESP32 Energy Meter (ATM90E32)