Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: budapestmetrodisplay
esphome:
name: ${name}
friendly_name: "BudapestMetroDisplay"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO0
mode: INPUT_PULLUP
inverted: true
name: "Button" # Boot button
status_led:
pin:
number: GPIO7
inverted: false # LEDs for display
# Other pins from the pinout:
# GPIO48: Status Led
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- AVATTO S06Pro WiFi IR Universal Remote Controller
- AVATTO Tuya WiFi Smart Switch Modul
- BlitzHome BH-AP1
- BlitzWolf BH-AP2501
- CircuitSetup Expandable-6 Channel ESP32 Energy Meter (ATM90E32)
- CircuitSetup Split Single Phase Energy Meter (ATM90E32) with ESP32
- CrowPanel 5.0" HMI ESP32 display (by Elecrow)
- Dikale Filament Dryer PCB by SiloCityLabs