Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: electriq-iqool-smart12hp
esphome:
name: ${name}
friendly_name: "electriQ IQOOL SMART12HP"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO13: UART Tuya RX
# GPIO15: UART Tuya TX
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- Doorbell Interface for ABB-Welcome
- Duux Bora Dehumidifier (DXDH02)
- Duux Whisper Flex Smart Fan (DXCF10)
- Duux Whisper Flex Ultimate Smart Fan (DXCF14)
- elvinhome CTRL ONE ePaper Room Controller
- ESPBell-LITE Intercom and Doorbell module
- eWeLink PCIe Computer Remote (SANT-SUD01)
- Generic 2CH Wifi Curtain Module