Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: generic-2ch-wifi-curtain
esphome:
name: ${name}
friendly_name: "Generic 2CH Wifi Curtain Module"
bk72xx:
board: generic-bk7231n-qfn32-tuya # BK7231T or BK7231N: check the chip marking
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
status_led:
pin:
number: GPIO19
inverted: false # LED
# Other pins from the pinout:
# GPIO11: S1, Curtain1 Open switch
# GPIO10: S2, Curtain1 Close switch
# GPIO9: S3, Curtain2 Open switch
# GPIO8: S4, Curtain2 Close switch
# GPIO4: L1, to Curtain1 Open motor
# GPIO17: L2, to Curtain1 Close motor
# GPIO20: L3, to Curtain2 Open motor
# GPIO2: L4, to Curtain2 Close motor
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.