Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: globe-4-inch-9w-downligh
esphome:
name: ${name}
friendly_name: "Globe 4 Inch 9W Downlight 50359"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO9: Ground
# GPIO8: 3V3
# TX: RX
# RX: TX
# GPIO3: PWM1
# GPIO10: PWM2
# GPIO6: PWM3
# GPIO5: PWM4
# GPIO4: PWM5
# GPIO1:
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- Cocoon DY180363 RGBW 8W Bulb
- Connect SmartHome 10W CCT Smart White LED Bulb B22 (CSH-B22WW10W)
- Connect SmartHome 10W CCT Smart White LED Bulb E27 (CSH-E27WW10W)
- Deta 10W 940lm Grid Connect Smart LED RGB CWWW Downlight (DET902HA)
- Globe Edison Bulb 34873
- Govee 6in recessed RGBCCT light
- Govee E27 5W 500lm RGBCCT Bulb
- H801/H802 RGBW LED controller