Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: govee-e27-5w-500lm-rgbcc
esphome:
name: ${name}
friendly_name: "Govee E27 5W 500lm RGBCCT Bulb"
rtl87xx:
board: generic-rtl8710bn-2mb-788k # check your module
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO10: Red Output
# GPIO7: Blue Output
# GPIO6: Green Output
# GPIO12: Cold White Output
# GPIO8: Warm White Output
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.
Similar devices
- Deta 10W 940lm Grid Connect Smart LED RGB CWWW Downlight (DET902HA)
- Globe 4 Inch 9W Downlight 50359
- Globe Edison Bulb 34873
- Govee 6in recessed RGBCCT light
- H801/H802 RGBW LED controller
- Holman RGB Wifi Connected Controller
- Kogan RGB + Cool & Warm White 2m LED Strip
- LEDENET Smart WiFi Led Controller (RGB/WW/CW)