Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: kincony-kc868-m16
esphome:
name: ${name}
friendly_name: "KinCony KC868-M16"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
# Other pins from the pinout:
# GPIO36: ANALOG_A1
# GPIO34: ANALOG_A2
# GPIO39: ANALOG_A3
# GPIO35: ANALOG_For_74HC4067
# GPIO4: IIC_SDA
# GPIO5: IIC_SCL
# GPIO14: 1-Wire GPIO
# GPIO16: 433MHz Receiver
# GPIO32: 74HC4067_S0
# GPIO33: 74HC4067_S1
# GPIO13: 74HC4067_S2
# GPIO16: 74HC4067_S3
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.