Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: m5stack-airq
esphome:
name: ${name}
friendly_name: "M5Stack AirQ"
esp8266:
board: esp01_1m # most plugs and relays have 1 MB flash; check yours
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO8
mode: INPUT_PULLUP
inverted: true
name: "Button" # Button B
# Other pins from the pinout:
# GPIO1: Ink Screen Busy
# GPIO2: Ink Screen RST
# GPIO3: Ink Screen D/C
# GPIO4: Ink Screen CS
# GPIO5: Ink Screen SCK
# GPIO6: Ink Screen MOSI
# GPIO9: beep
# GPIO10: SEN55 Power Switch
# GPIO11: SEN55 SDA
# GPIO12: SEN55 SCL
# GPIO26: Speaker Pin 2
# GPIO15: GROVE A SCL
# GPIO13: GROVE A SDA
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.