Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: m5stack-fire
esphome:
name: ${name}
friendly_name: "M5Stack Fire"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO39
mode: INPUT_PULLUP
inverted: true
name: "Button 1" # Button A
- platform: gpio
pin:
number: GPIO38
mode: INPUT_PULLUP
inverted: true
name: "Button 2" # Button B
- platform: gpio
pin:
number: GPIO37
mode: INPUT_PULLUP
inverted: true
name: "Button 3" # Button C
# Other pins from the pinout:
# GPIO34: Microphone Pin
# GPIO25: Speaker Pin 1
# GPIO26: Speaker Pin 2
# GPIO22: GROVE A SCL
# GPIO21: GROVE A SDA
# GPIO36: GROVE B SCL
# GPIO26: GROVE B SDA
# GPIO16: GROVE C RXD
# GPIO17: GROVE C TXD
# GPIO15: SIG Pin
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.