Starter ESPHome config
Built from the pinout above. Keys and the Wi-Fi password come from secrets.yaml in ESPHome. Check the pins against your hardware revision before flashing: one model can ship with different boards.
substitutions:
name: m5stack-m5stickc-plus2
esphome:
name: ${name}
friendly_name: "M5Stack M5StickC PLUS2"
esp32:
board: esp32dev
logger:
api:
encryption:
key: !secret api_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
ap: {}
captive_portal:
binary_sensor:
- platform: gpio
pin:
number: GPIO37
mode: INPUT_PULLUP
inverted: true
name: "Button 1" # Button A
- platform: gpio
pin:
number: GPIO39
mode: INPUT_PULLUP
inverted: true
name: "Button 2" # Button B
- platform: gpio
pin:
number: GPIO35
mode: INPUT_PULLUP
inverted: true
name: "Button 3" # Button C
status_led:
pin:
number: GPIO19
inverted: false # Internal LED/IR
# Other pins from the pinout:
# GPIO13: SPI CLK
# GPIO15: SPI MOSI
# GPIO21: I2C SDA
# GPIO22: I2C SCL
# GPIO5: Display CS
# GPIO14: Display DC
# GPIO12: Display Reset
# GPIO0: I2S CLK
# GPIO26: I2S LRCLK
# GPIO34: Microphone Data
# GPIO38: Battery Level
# GPIO2: Buzzer
How to flash
- Most devices are flashed over UART: a 3.3 V USB-TTL adapter to RX, TX, GND and 3V3, holding GPIO0 to ground at power-on (ESP8266/ESP32). Mains power disconnected.
- Beken (BK72xx) and Realtek chips are flashed with ltchiptool, or with cloudcutter without opening the case if the firmware allows it.
- Details and board photos: the device page in the ESPHome database.
A config from scratch: ESPHome generator. Which pins are safe: pinout.